S355JR vs S355J2: What Impact Test Temperature Means for Charpy
The letters after S355 tell you the Charpy test temperature: JR at +20 °C, J0 at 0 °C, J2 at −20 °C. Here is what that means for testing, specimen...
Ameet Kudche |
The letters after S355 tell you the Charpy test temperature: JR at +20 °C, J0 at 0 °C, J2 at −20 °C. Here is what that means for testing, specimen...
Ameet Kudche |
The charpy v notch specimen preparation and test procedure starts with identifying the governing test standard, then preparing and checking the notched specimen, conditioning it if required, verifying the machine,...
Akuracy |
ISO 9513 grades extensometers into classes by their errors. Here is what class 0.5 and class 1 allow in microns, which class a tensile test to ISO 6892-1 needs, and...
Ameet Kudche |
The answer to “how do I calculate impact strength?” starts with the energy absorbed when a specimen breaks and the specimen’s dimensions at the fracture section.
Akuracy |
Selecting the right Universal Testing Machine (UTM) can be a daunting task, especially when you are seeking reliability and long-term performance. A critical factor in making this decision is assessing...
Madhav Shastri , Material Science Expert |
Hardness conversion charts are empirical, material-specific and approximate. Here is how to convert HRC to HV and HB correctly, which tables to cite, and when you must test on the...
Ameet Kudche |
Dynamic balancing machine selection for industrial maintenance teams starts with the rotors you service, the corrections you make, and the measurement evidence your process requires.
Akuracy |
Static unbalance can be fixed in one plane; couple and dynamic unbalance need two. Here is how to tell them apart, why it matters for fans, rotors and crankshafts, and...
Ameet Kudche |
A 20-ton UTM machine does not have one fixed price in India; the quotation depends on the machine configuration and the requirements it must meet.
Akuracy |
When investing in a Tensile Testing Machine, it is vital to consider various factors to ensure you get the most value for your purchase. Among the many aspects to evaluate,...
Madhav Shastri , Material Science Expert |
An 8.8 bolt has a nominal tensile strength of 800 MPa and a 640 MPa yield. Here is how a QC lab checks tensile strength, proof load and HRC hardness...
Ameet Kudche |
Flexure testing measures how a specimen responds to bending, with flexural strength calculated from the maximum load and the specimen’s dimensions using the method specified for its material.
Akuracy |
The difference in ultimate tensile strength vs yield strength is the point each value describes on a material’s response to tension.
Akuracy |